How We Repair Your Reach-in Cooler
Refrigerators, coolers and prep tables all depend on a compressor, two fans, a sealed refrigerant loop and a defrost system working together.
Common Reach-in Cooler Problems We Fix
Ice maker or dispenser not working
A frozen fill tube, a bad water inlet valve, a clogged filter or a failed ice maker module.
Not cooling or running warm
Usually a dirty condenser coil, a failed condenser or evaporator fan, a bad start relay or a defrost problem that has iced over the evaporator. A sealed-system leak is less common but possible.
Freezer works but the fresh-food side is warm
Classic sign of a frosted-over evaporator or a stuck air damper. The defrost heater, thermostat or control is checked first.
Water on the floor or under the crisper drawers
A clogged defrost drain, a cracked drain pan or a leaking water inlet valve or supply line.
Clicking, buzzing or loud running
A failing start relay makes the compressor click on and off; a worn fan motor or ice on the fan blade causes buzzing or rattling.
Runs constantly
Dirty coils, a torn door gasket letting warm air in, a failing fan or low refrigerant.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Make sure the temperature controls were not bumped (37-40°F fresh food, 0°F freezer).
- Vacuum the condenser coils at the bottom or back and clear anything blocking the vents.
- Close a dollar bill in the door: if it slides out easily, the gasket may not be sealing.
- Listen for the fan inside the freezer when the door switch is pressed.
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your reach-in cooler is doing and when it started. We schedule the first available visit, with priority for equipment that is stopping your business.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Start relay and overload
- Condenser and evaporator fan motors
- Defrost heater, thermostat and timer or control board
- Door gaskets
- Water inlet valve
- Ice maker assembly
- Thermistors and temperature sensors
Cost and Lifespan
Most reach-in cooler repairs cost $150–$450 including parts and labor, and these appliances typically last 10–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Keep door gaskets clean and check them for tears
- Leave space around the unit for airflow
- Vacuum the condenser coils every six months
- Replace the water filter every six months
Reach-in Cooler Repair in Florida
We repair reach-in coolers in 349 cities and towns across Florida. Long, humid summers in Florida push refrigerators, ice makers and AC units in homes across the state hard for most of the year. Hard water is common in Florida, and scale is one of the first things we check on water-using appliances like this one.
Frequently Asked Questions
How much does Reach-in Cooler Repair cost in Florida?
Most reach-in cooler repairs fall between $150–$450 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my reach-in cooler today?
Same-day visits depend on technician availability in Florida. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Which brands of reach-in cooler do you repair?
We repair all major brands. See the brand list on this page, or call with your model number and we will confirm.
Should I repair or replace my reach-in cooler?
A reach-in cooler typically lasts about 10 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.